iSoaker.net : Welcome Again! ::

by **Speedbeetle06** on Thu May 04, 2006 8:08 pm

Today I got the MI Helix, filled up the gun and the pack with water and tested it out. When the blaster ran out of water, no water from the backpack was sent to the gun when I pulled the pump out, making the backpack totally usless. Is there anything I can do to get water to the gun?

:bmhelix:

by **isoaker_com** on Thu May 04, 2006 8:11 pm

Either the backpack connection wasn't attached properly or the cap on the MI Helix was loose, allowing air in instead of drawing water from the backpack.

For the MI system to work, the cap on the blaster must be on tightly and the backpack attachment must be inserted fully to open the valve.

:cool:

by **Speedbeetle06** on Thu May 04, 2006 8:20 pm

Hmmm... I didn't think of that. I'll test it again tomarrow and post again (or probably edit this post so I don't don't double post)and see if that was the problem.

Thanks!

by **isoaker_com** on Thu May 04, 2006 8:30 pm

If tighten things doesn't work, double check there is nothing stuck in the hose that might be clogging it. If you push on the valve with the backpack's cap loose and hold the backpack above the hose's end, you should be able to get water to flow.

:cool:

by **SharpObjects** on Thu May 04, 2006 8:34 pm

The soaker must be below the pack in order to recieve water. Just hold it below and water should start to flow into the helix.

by **Hannibal** on Thu May 04, 2006 10:32 pm

An be careful to losen the cap on the gun or you'll end up with a collapsed water tank. That's why I'm returning my Flash flood and Aquapack. I needed the water the Aquapack provided, and there's no chance I'll remember to loosen the cap ever time I use it. And were I to loan out my FF to someone else, they wouldn't know to loosen the cap.

Edited By Hannibal on 1146800006

by **Speedbeetle06** on Sun May 07, 2006 11:11 am

Ok sorry I haven't posted in a couple days, but here's what the problem was.
when you fill the pack, you must sqeeze it to make the water go to the end of the hose. Then when you fill the blaster, it must be COMPLETELY full. When you attach the pack to the gun, the gun must be under the pack and the hose must be vertical, so when the gun and the pack are attached, the water from the pack and the water from the gun are mixed. That way, there is one continous flow of water to the gun.
:bmhelix:

iSoaker.net : Welcome Again! ::

'06 Helix Problem - Please Help

Who is online